What kind of Dolphin Decorative Window Film Privacy Glass Door Tint Sticker do you need?
Privacy rating Top private film, outstanding privacy protection available for most cases even for bathroom . Frosted design provides privacy and allow soft light in. Non Adhesive Static Cling - Removable and reusable. Easy to position and remove without any residue or any harmful substances release, so it can be reused if not damaged or smudged. Anti-UV Window Tint - Keep heat out in summer and retain it in winter comfort. Control heat, block out more than 98 of harmful UV Rays, stop the staffs in door from fading and aging. Size - 35.5*118.2 inch 90*300cm per roll, easily trimmed to required size with scissors or utility knife. Patterns can not ally. Easy Application Only use on clean and smooth glass. You only need some water to apply it. DON T forget to remove backing protective film before putting on glass Detail instructions, please see the product description below .
Is this what you need when you buy Dolphin Decorative Window Film Privacy Glass Door Tint Sticker?
Notice This No-glue film is only for smooth glass.Can not fit to frosted glass or art glass. Installation Step 1. Measure windows and trim film Step 2. Clean glass, then wet glass with soapy water or just clear water also work well Step 3. Affix taps on both sides to remove the transparent backing film. which is a kind of clear vinyl, please MAKE SURE remove it before you apply the window film to glass Step 4. Apply to wet glass and smooth with a smooth tool,such as a credit card or a spatula,or hands Step 5. Squeegee away water and air bubbles Step 6. Cut off the margins. Q A Q1 Why my film do not stay A Have not wet the window with water, or have not remove the transparent backing film. S Remove the transparent backing film, and then wet the window with soapy water. Q2 I have removed the back film and wet the widow, why still can not stay A You apply the wrong side. The film is divided into two layers, one side is smooth, and the other side is rough. S Tear it off and retry another side to paste again. Q3 There are a large number of small bubbles. A Too less water. S Tear it down, spray a lot of water and paste it again. Tips for Installation 1.A clean and smooth glass surface without any dust, fiber or any kind of texture is needed. 2. The transparent back cover must be peeled off otherwise, the film will fall off when the water is dry. 3. Do not apply to the window frame. Cut off excessive edges after application if needed. 4. The film may be a little tough and its adhesive effect will be impacted in winter. Solution use hair dryer or warm water to soft it. Heat resistance is under 176 .
Customer reviewsNice Window Treatment
Wanted a vinyl cover for a glass window over our front and deck doors to eliminate the empty look. Instructions pretty straight forward, since they are horizontal, took two of us to apply. Once on and trimmed to size, it looked great. Only wish the pattern was for a horizontal fit.